Category Archive Control Cabinet

ByNikisae Elevator

Micolift Control Panel

MICOLIFT M3P full computer control computer since its introduction , with its unmatched reliability , friendly community, low price , quickly won the trust of customers , becoming lift production , transformation and technological upgrading product of choice for today’s mainstream technology development direction of the elevator . Has now been adopted by dozens of domestic elevator factory .
Note : MICOLIFT M3P microcomputer operating voltage of DC 24V, if the operating voltage AC 220V wrong access M3P will damage the computer .

MICOLIFT M3P computer , using parallel communication directly within 8 layers parallel signal processing , control board 5- layer system board technology , the upper and lower sides essentially cover layer, and using surface mount technology , which greatly improved anti-jamming capability . Through friendly interface , commissioning personnel without programming , according to site conditions can enter a few simple parameters , it has the following characteristics :
1. wells autotuning .
2. high-speed counting technique and accurate positioning technology , higher precision leveling .
3. can be registered and displayed outside the elevator and the election call command signal directly on the computer operator .
4. can directly regulate self-closing time and opening and closing time protection .
5. the signal can be set to any elevator floor does not respond directly on the computer
6. can be set to single / double door does not open and the corresponding floor .
7. floor display can be set to BCD , seven-segment code or Gray code .
8. Can be set to any base station and landing Fire returned.
9. Showing the number of pulses on each floor , and the current location of the car after the self-learning .
10. Enabling parallel operation .
11. 50 Fault History .
12. Can display elevator running curves.
13. Which can be accessed remotely monitor or cell monitoring.

Set in one of a variety of superior performance , can make timely and accurate processing when the elevator failure, and Do some pre-emptive work , you feel the essence of people-oriented technology .

 

 

ByNikisae Elevator

CONTROL PANEL CP-FJ8-INV

Control Panel CP-FJ8-INV

Control Panel Elevator yang berbasis teknologi microprocessor yang dirancang untuk mesin roomless maupun worm gear dengan kecepatan hingga 150 MPM dan sangat cocok untuk low rise dan medium rise. Menggunakan teknologi dan komponen yang berkwalitas tinggi dan mengikuti standart kwalitas internasional sehingga diperoleh sebuah produk sistem yang tak diragukan lagi kehandalanya. Ingat bahwa Lift passenger, home elevator atau bed lift dikendalikan oleh sistem control. Jadi tanpa kehandalan sistem control maka menyebabkan lift anda akan mengalami banyak masalah.

Sistem control ini telah banyak terpasang di mall, perumahan, kantor, rumah sakit, apartement dan bangunan komersial lainya.

1. Electric Spesification :
Main Power : AC170V-240V, 50/60Hz or AC340-440V, 50/60Hz
Control Circuit Power : DC24,5, 8.5A (up to 16 stops), 15A(over 17 stops)
Cab Lighting & Fan Power : AC100V-120V or AC200-230V, 200W Max
Brake Unit : DC100V or DC200V (as per order)
CPU : DC5V/2A working power & DC24V/1A driving power

2. Operation Enviroment :
Temperature : 0°C~55°C
Humidity : 35~85RH without condence
* Exposure in corrosive air should be avoided
* Vibration should be avoided

3. Outside Dimension
H*W*D : 1200*600*280 (inverter capasity up to 15kw)
* The outside dimension is subject to change according to the special requirement and output capacity

Fuji Elevator Control

[table id=7 /]

error: