Category Archive Spare parts Elevator

ByNikisae Elevator

Safety Device Cargo Lift

Safety Device Cargo Lift

safety device cargo liftFungsi sebagai pengaman rantai (rope) putus lift cargo atau lift barang, design-nya sangat simple dan pemasangan sangat mudah.

Untuk pemesanan silahkan hubungi kami

[table id=7 /]

ByNikisae Elevator

Micolift Control Panel

MICOLIFT M3P full computer control computer since its introduction , with its unmatched reliability , friendly community, low price , quickly won the trust of customers , becoming lift production , transformation and technological upgrading product of choice for today’s mainstream technology development direction of the elevator . Has now been adopted by dozens of domestic elevator factory .
Note : MICOLIFT M3P microcomputer operating voltage of DC 24V, if the operating voltage AC 220V wrong access M3P will damage the computer .

MICOLIFT M3P computer , using parallel communication directly within 8 layers parallel signal processing , control board 5- layer system board technology , the upper and lower sides essentially cover layer, and using surface mount technology , which greatly improved anti-jamming capability . Through friendly interface , commissioning personnel without programming , according to site conditions can enter a few simple parameters , it has the following characteristics :
1. wells autotuning .
2. high-speed counting technique and accurate positioning technology , higher precision leveling .
3. can be registered and displayed outside the elevator and the election call command signal directly on the computer operator .
4. can directly regulate self-closing time and opening and closing time protection .
5. the signal can be set to any elevator floor does not respond directly on the computer
6. can be set to single / double door does not open and the corresponding floor .
7. floor display can be set to BCD , seven-segment code or Gray code .
8. Can be set to any base station and landing Fire returned.
9. Showing the number of pulses on each floor , and the current location of the car after the self-learning .
10. Enabling parallel operation .
11. 50 Fault History .
12. Can display elevator running curves.
13. Which can be accessed remotely monitor or cell monitoring.

Set in one of a variety of superior performance , can make timely and accurate processing when the elevator failure, and Do some pre-emptive work , you feel the essence of people-oriented technology .

 

 

ByNikisae Elevator

Door Switch-KCB 3

KCB 3 – Bistable Switch

KCB-3 bistable switch

 

 

 

 

 

 

 

 

 

 

 

Application in elevator door,providing no contact signal transfer.

Power: 100~120w;voltage:250VAC/DC;current:3.0A;shock-resistance:50G
Dielectric strength: 800VDC
Insulation resistance: 10^11 Ohms
Switching time without bounce: 3.5MS
Release time: 0.2ms
Testing distance:5mm~15mm
Bistable door swtich is with dustproof and explosioon-proof plastic case,foreign-made reed swith with original package,high life.
Actuating magnet choice depends on actual environment conditions
Buy high quality elevator bistable swith from us with good price!

ByNikisae Elevator

Microswitch-Z-15GW2

Microswitch-Z-15GW2

Microswitch-Z-15GW2

ByNikisae Elevator

Traveling Cable H05VVH2-F

Traveling Cable H05VVH2-F

Kabel traveling

[table id=7 /]

 

 

error: